As for automatic vegetable cutting machine, it is very simple to polarize, either put it on the shelf or not protect it well when it is in use, which constitutes severe wear and tear.
In fact, shelving automatic vegetable cutting machine is a kind of wear and tear. When shelving, it will constitute a condition of corrosion and wear. Corrosion and wear refers to the loss of information caused by the corrosion of conflict pairs. Corrosion wear is formed under conflicting conditions. Corrosion wear in wet environment is faster than other wear. That's why machines can't be shelved for a long time.
So it is also important to prevent physical wear and tear of the automatic vegetable cutting machine which is often used. Although the progresses of automatic vegetable cutting machine planning have tried to reduce this kind of wear, due to the limitation of life, wear can not be prevented for many times. The corrosion and wear mentioned above belong to chemical wear. Now let's know some phenomena of physical wear and ways to prevent it.
The simple component data between the roll and the tooth roll of the automatic vegetable cutting machine are transferred from one appearance to another, and the components are damaged due to seizures. This is due to the fact that the same kind of data is more easily adhered to in physics than the different kinds of data; the operation between the same kind of data often occurs in the middle of the tooth rolls, and the sticking wear between the dough and the machine is more common among the rolls. We should prevent the biting of rollers and gear rollers during operation.
2. When there are large hard particles in the roll pairs of the automatic vegetable cutting machine, many grooves will be drawn on the surface of the parts. Therefore, when producing noodles, the flour should be clean and the dough should be even. As long as the data hardness of the automatic cutting machine equipment is high and the pulmonary grain of the roll of the automatic cutting machine equipment is not too large, the wear and tear will be reduced to a certain extent.
3. We know that every kind of steel equipment has fatigue value. When the exterior of auto-cutting machine parts is repeatedly subjected to kneading and other high-strength loads, the information that constitutes the part sheet will gradually fall into blocks, resulting in a pit-like pit on the part exterior, which constitutes wear and tear.
Automatic vegetable cutting machine manufacturers use the better information to ensure that the maximum anti-fatigue value of the automatic vegetable cutting machine, together advocate that users can also greatly improve the anti-fatigue wear ability of parts, advocate that equipment is often lubricated.
When a solid surface is impacted by a flow break containing hard particles, erosion wear will occur on the surface, such as the erosion of rivers to rivers, and sometimes erosion wear can be used, such as cleaning up drilling sand attached to castings, and spraying the castings with high-speed airflow containing hard sand particles, which can effectively eradicate drilling holes on the surface of castings. Sand and bulge make the casting table cleaner and more lubricated.
The above information is organized and released by our Ding Cutter. If you want to know more about it, please continue to pay attention to our website: http://www.mosquitolanding.com. Thank you for your support!